ST37-2 I Beam

May 07, 2024 Leave a message

1. Introduction to St37-2 carbon structural steel

ST37-2 is a common structural steel used in construction and underground engineering. Performance and flaw detection analysis of St37-2 steel plate made of standard DIN17100 material@Wugang. ST37-2 is a carbon structural steel material brand in Germany. This material corresponds to the carbon structural steel Q235B in my country (the old brand is: A3-B). It is mainly used in construction and underground engineering. In addition, because this kind of steel is similar to my country's high-quality carbon structural steel 20 steel, it can also be replaced by 20 steel.

i

 

3. ST37-2 steel plate delivery status: hot rolling, exploration rolling, and normalizing.

ST37-2 is a common structural steel used in construction and underground engineering.

Implementation standards: German steel standards.

Delivery status: hot rolling, exploration rolling or normalizing

Technical conditions: The chemical composition and mechanical properties of this steel are briefly shown in the table below. Impact, flaw detection, Z-direction, composition control, performance requirements exceeding standards, etc. can be added when ordering.

i beam

4. Chemical composition of ST37-2 steel plate:

C: 0.21-0.25

N≤0.009

P≤0.065

S≤0.065

5. Mechanical properties of ST37-2 steel plate:

Tensile strength Mpa: 340-470

Yield strength Mpa: ≥235

Minimum elongation, %, A: +20 degrees

Impact power: 27J minimum

i