Q355 A992 I Beam

Apr 03, 2024 Leave a message

I-beams are widely used in the construction industry and are available in a variety of standard sizes. Tables are available to allow easy selection of a suitable steel I-beam size for a given applied load. I-beams may be used both as beams and as columns.

i beam

 

I-beams may be used both on their own, or acting compositely with another material, typically concrete. Design may be governed by any of the following criteria:

deflection: the stiffness of the I-beam will be chosen to minimize deformation

vibration: the stiffness and mass are chosen to prevent unacceptable vibrations, particularly in settings sensitive to vibrations, such as offices and libraries

bending failure by yielding: where the stress in the cross section exceeds the yield stress

bending failure by lateral torsional buckling: where a flange in compression tends to buckle sideways or the entire cross-section buckles torsionally

bending failure by local buckling: where the flange or web is so slender as to buckle locally

local yield: caused by concentrated loads, such as at the beam's point of support

shear failure: where the web fails. Slender webs will fail by buckling, rippling in a phenomenon termed tension field action, but shear failure is also resisted by the stiffness of the flanges

buckling or yielding of components: for example, of stiffeners used to provide stability to the I-beam's web.

STEEL i beam

Issues

Though I-beams are excellent for unidirectional bending in a plane parallel to the web, they do not perform as well in bidirectional bending. These beams also show little resistance to twisting and undergo sectional warping under torsional loading. For torsion dominated problems, box beams and other types of stiff sections are used in preference to the I-beam.

i beam