Cold Bending Process Of Steel Plate

Apr 12, 2024 Leave a message

(1) Since the high-rigidity steel formed by high-strength plates has a large moment of inertia and bending modulus, especially because the application requirements require pre-punching and cold bending, the surface flatness and material quality will be affected. Due to the difference in edge size, it is required to add more lateral positioning devices in the design of the cold-formed pass of this type of high-strength structural steel plate, reasonably design the pass, and reasonably arrange the roll gap, etc., to ensure that the material entering each pass is not deviation and try to eliminate as much as possible the influence of differences in material surface flatness and material edge size on subsequent cold-bent forming shapes; another outstanding feature is: the forming springback of high-strength structural steel plates is serious, and springback can cause If a curved edge appears, it must be corrected by cornering, and the cornering angle is difficult to master, so adjustments and corrections need to be made during the production and debugging process.

plate

 

(2) More molding passes are required. In the roll cold bending forming process, the main processing process is bending deformation. Except for the slight thinning of the bending angle of the product, the thickness of the deformed material is assumed to remain unchanged during the forming process; when designing the pass, attention should be paid to the reasonable distribution of deformation. The amount, especially in the first pass and the following passes, is to prevent the deformation from being too large. In addition, side rollers and over-bending rollers can be used to pre-bend the profile, and the neutral line of the profile section coincides with the neutral line of the finished profile, so that the forces on the upper and lower parts of the profile are balanced to avoid longitudinal bending. If longitudinal bending is found during processing, some rollers can be added according to the actual situation, paying special attention to the following passes.
Other measures such as using a straightening machine for straightening, changing the distance between racks, using supporting rollers, and adjusting the roll gap of each rack can reduce or eliminate longitudinal bending. It should be noted that adjusting the roll gap of each pass to reduce longitudinal bending requires skilled technology.

plate

(3) The roller cold bending speed should be controlled and the forming roller pressure should be adjusted appropriately to minimize fatigue cracks due to repeated cold bending, and proper lubrication and cooling should be carried out to further reduce the occurrence of thermal stress cracks, etc., and control the bending radius, that is, bending The radius cannot be too small, otherwise cracks will easily occur on the surface of the product. In view of the post-ductile fracture phenomenon that occurs in high-strength plates during the cold forming and cold bending process, in order to meet the structural design requirements, it is recommended to optimize the cross-sectional shape while meeting the mechanical design requirements of the material. Methods such as increasing the corner radius, reducing the cold bend angle or increasing the cross-sectional shape are also effective methods.

plate