S355J2 European standard alloy steel plate introduction

Mar 11, 2024 Leave a message

S355J2-N-MTC-steel-plate.pdf

S355J2 is a European standard alloy plate, which is a low alloy high-strength structural steel with good impact toughness and welding function.


S355J2 adopts electric furnace steelmaking, made from scrap iron steelmaking, steel quality is pure, steel plate is poured with steel, cooled and pressed into flat steel. It is flat, rectangular, and can be rolled directly or sheared from a wide steel strip. Steel plate by thickness, thin steel plate <8 mm (the thinnest 0.2 mm), medium-thick steel plate 8 ~ 60 mm, extra-thick steel plate 60 ~ 120 mm.

S355J2 steel plate implementation standards: the implementation of EN10025-2: 2004. (Old standard EN10025: 1990) standards.


S355J2 steel plate delivery status: steel plate is delivered in hot rolled, controlled tie, normalized and other states, and can also be specified according to technical requirements of the delivery state.


S355J2 steel plate chemical composition analysis:

S355J2 steel plate carbon content C: ≤ 0.24

S355J2 steel plate silicon content Si: ≤ 0.55

Manganese content of S355J2 steel plate Mn: ≤1.6

S355J2 steel plate phosphorus content P: ≤0.025

S355J2 steel plate sulfur content S: ≤0.025

S355J2 steel plate copper content Cu:≤0.05

 

The surface of steel plate should not have bubbles, scars, cracks, folding, inclusions and pressed into the iron oxide and other harmful defects affecting the use of steel should not be visually visible delamination. The surface of the steel is allowed to do not prevent the inspection of surface defects of the thin layer of iron oxide, rust and due to the press into the iron oxide and rolls caused by the inconspicuous roughness, mesh, scratches and other local defects, but its depth should not be greater than the thickness of the steel tolerance of half, and should ensure that the minimum thickness of steel allowable surface defects in steel allow grinding and other methods to remove, clean up the place should be smooth and no edges, clean up the depth should not be greater than the thickness of steel negative deviation. Negative deviation of steel thickness, and should ensure that the minimum thickness of steel allowed.

China hsla structural steel Distributors

China high strength steel sheet Distributors

China high strength sheet metal Suppliers