About the basic mechanical performance standards of LR Ship Class.

Aug 08, 2025 Leave a message

1. Yield Strength Requirements

LR defines minimum yield strength values to ensure load-bearing capacity.

Standard Grades:

LR Grade A: ≥235 MPa.

LR Grade EH36: ≥355 MPa.

Testing Method:

Tensile tests per ISO 6892-1 at room temperature (20°C).

Samples taken transversely from plates >20mm thick.

Thickness Impact:

Yield strength may decrease by 10–15 MPa for plates >50mm due to cooling rate variations.

LR Rule Reference: Pt.3, Ch.2 of LR Rules for Materials.


2. Tensile Strength (Rm) and Ductility

LR mandates tensile strength ranges and minimum elongation for structural reliability.

Typical Ranges:

Grade A: 400–520 MPa.

EH36: 490–620 MPa.

Elongation (A₅₀):

Grade A: ≥22% .

EH36: ≥21%.

Fracture Control:

Reduction of area (Z) ≥45% for critical applications (e.g., hull girders).

Note: TMCP-processed steels often show higher elongation than normalized grades.


3. Charpy Impact Toughness

LR specifies impact energy values at designated temperatures.

Test Conditions:

Charpy V-notch (CVN) per ISO 148-1.

Sample Orientation: Longitudinal (L) or transverse (T).

Grade-Specific Requirements:

Grade D: ≥27J at -20°C (L-T direction).

EH36: ≥34J at -40°C (both L-T and T-L for ABS equivalence).

Arctic Grades:

EH40 Arctic: ≥60J at -60°C (additional thickness constraints).

Testing Frequency: 1 test per 50 tons for LR-certified batches.


4. Bend Test Performance

Bend tests validate formability and surface integrity.

Standard Requirements:

180° bend test with mandrel diameter = 2× plate thickness for Grade A.

No cracks allowed after bending.

High-Strength Steels:

EH36/FH40: May require 3× thickness mandrel due to reduced ductility.

Alternative Tests:

Guided bend tests for weld procedure qualifications.

LR Compliance: Bend tests are mandatory for as-rolled plates but waived for TMCP grades with proven toughness.


5. Through-Thickness (Z-Direction) Properties

LR enforces Z-testing for thick plates to prevent lamellar tearing.

When Required:

Plates >40mm thick in highly restrained joints (e.g., T-joints).

Acceptance Criteria:

Z25: Minimum 25% reduction of area.

Z35: Required for ice-class vessels (35% reduction).

Testing Standard:

ISO 27306 for Z-direction tensile tests.

Case Study: LR rejected a 60mm EH36 batch due to Z-test results <20%.